AMT Pump 4230-97 Coolant Recirculating Pump, Bronze, 1/25 HP, 1 Phase, 115V, 3/8" NPT Female Discharge Port

This AMT 4230-97 coolant recirculating pump has a cast bronze casing, column, and base, a 3/8" female NPT discharge port, and a 1/25 hp, 115V, 1 phase TEFC motor. The cast bronze impeller and shaft resist corrosion. The self-cleaning, semi-open impeller is more efficient than an open impeller and is less likely to clog than a closed impeller. This pump handles erosive liquids with viscosities up to 900 Saybolt Seconds Universal (SSU). The totally enclosed, fan cooled (TEFC) electric motor is protected against dust and indirect water spray but is not submersible. This pump is suitable for use in coolant recirculating applications such as in chemical etching.SpecificationsMotor1/25 hp, 115V, 1.5 amp, 1 phase TEFC, 1590 RPM, 3' three-conductor cordPumpCentrifugal, no bottom bearingMaximum flow rate6 gpmImpellerCast bronze, self-cleaning, semi-openDischarge port3/8" NPT femaleMaximum immersion depth6"Maximum liquid operating temperature200 degrees FMaximum liquid viscosity900 SSUDimensions*5.3/134.6** x 4.4/111.7** x 12.4/314.9 (L x W x H) inches/millimeters* L is length, the horizontal distance from front to back; W is width, the horizontal distance from left to right; H is height, the vertical distance from lowest to highest point**This measurement may vary due to engine manufacturer's specificationsPumps use mechanical action to move liquids, gases, or slurries (solids suspended in a liquid or gas). The mechanical action is categorized as either positive displacement (PD) or kinetic. PD pumps capture and release discrete amounts of flow into a chamber and then force it out. Some examples of PD pumps are fuel and oil pumps in cars, pumps in hydraulic systems, and bicycle pumps. Kinetic pumps move liquids, gases, or slurries by transferring energy from the pump's movement to the flow. They use an impeller to draw the flow in, add energy to the flow, and move it through a volute (a spiral funnel through which the flow moves), and into the system. Some examples of kinetic pumps include centrifugal (the most common pump in industrial applications), in-line pumps, sump pumps, and suction pumps. Energy sources for all types of pumps include wind power, manual operation, electricity, and gasoline or diesel fuel.American Machine and Tool (AMT) manufactures centrifugal and diaphragm pumps. The company is headquartered in Royersford, PA.

• Self-cleaning, semi-open impeller for use in coolant circulating applications
• 1/25 hp, 115V TEFC electric motor
• Cast bronze casing, column, and base
• Maximum operating temperature 200 degrees F
• Pump must be mounted above fluid level